RE: [multipsk] DXLauncher197


Nov 17, 2016

 


----------------------------

#22482 Nov 17, 2016

Hi Group.

Would like to scan frequencies that Multipsk provides using my Elad FDM-SW2 SDR with Commander from DXLauncher197. Receiving only. Using Yaesu FT897 CAT to control the SW2 on Com port pairs 3 and 4.Multipsk shows Connected into Commander. Under QRGs in Multipsk clicking on a frequency the Commander VFO correctly changes to the frequency that is in database. 

So my problem is how do I sent the CAT command to the SW2 to change frequencies from Multipsk via Commander? 

Thank you for your interest.

Greg



----------------------------

#22483 Nov 17, 2016

>>AA6YQ comments below



-----Original Message-----

From: multipsk@yahoogroups.com [mailto:multipsk@yahoogroups.com]

Sent: Thursday, November 17, 2016 6:33 AM

To: multipsk@yahoogroups.com

Subject: [multipsk] DXLauncher197



Would like to scan frequencies that Multipsk provides using my Elad FDM-SW2 SDR with Commander from DXLauncher197.

>>>The current version of the DXLab Launcher is 2.10. You can upgrade by opening the Launcher's Configuration window, selecting the "DXLab Applications" tab, and clicking the Launcher's Upgrade button.



Receiving only. Using Yaesu FT897 CAT to control the SW2 on Com port pairs 3 and 4.



Multipsk shows Connected into Commander. Under QRGs in Multipsk clicking on a frequency the Commander VFO correctly changes to the frequency that is in database.



So my problem is how do I sent the CAT command to the SW2 to change frequencies from Multipsk via Commander?

>>>Connect you SW2 to Commander's Secondary CAT port using the appropriate topology shown in



www.dxlabsuite.com/dxlabwiki/SDRInteroperation>



73,



Dave, AA6YQ



----------------------------

#22484 Nov 17, 2016

Hello Greg,  If the Commander is connected to Multipsk, you must configure Commander which will control your receiver through CAT commands (if expected by Commander for your receiver).Nota: Multipsk does not send CAT commands, but sends commands to Commander.  The Yahoo group for Commander:*> To visit your group on the web, go to:... groups.yahoo.com/group/dxlab/  73Patrick  De : multipsk@yahoogroups.com [mailto:multipsk@yahoogroups.com] Envoy. : jeudi 17 novembre 2016 12:33. : multipsk@yahoogroups.comObjet : [multipsk] DXLauncher197


S
e
n
i
o
r
T
u
b
e
.
o
r
g