#44489 Dec 2, 2009
> Thanks Paul,
> OK I.ll try again.
> I have changed the gearboxes so in Gemini it says MI250 and in Pempro Gemini Level 4. But this is OK from what I
> But when programming Gemini should I use "Current PEC table" or "Saved PEC table" ?
You should use "Current PEC table".
> About the index value - if I start a new imaging session next day and before I power up Gemini I point the telescope,
by hand, to the > pole, does this "destroy" the programming in Gemini ?
I believe that if you have 1.04 (or later) firmware then the PEC Index will be restored correctly.
Timo, if you still have problems getting the PEC to work please post your PEMPro log files (before and after PEC
correction) either to the files section here or to the CCDWare PEMPro support forum (you can easily get to the PEMPro
forum from the Help menu in PEMPro).
Author of PEMPro